airliner-civil-aircraft-modeller.com

So, in an attempt to restore my mojo - which has been gone for a loooooong time! - I decided to bite the bullet and build one of my Williams Bros. Ford Flivvers. I have plans for the second one as a WIF, and those in Australia *might* be able to guess what I have in store for it...

Anyhoo, this is my progress so far - painting and decalling the wings and horizontal stabilizer. Unfortunately some of the decals cracked while drying, but it'll never be in a competition, so I'm not *really* worried about it.

looking good so far.

Nice!!!
And geez.....do I hear ya about lack of mojo
TOR

Nice work knackers

I'm not sure whether to try to use pieces from the remaining decals to cover the cracks or not. I ended up spraying the remnants of the sheet with Testors decal bonder, so we'll see..

Also started to close the fuselage. It was a little tricky - I had to trim one side of the IP to remove a gap in the front fuselage, and there are no locating pins. Still, so far, so good.

So I got off my butt and did some more painting. I used Mr Colour Phthalo Cyanne Blue and SMS Aluminium. Masking it was a bit of a pain....took me three goes to get it right (ish).





It's almost at the point where I can run around my lounge making BRRRRRRMMMMMM noises..