This was built last year, it's the old 70s Heller kit but re-boxed by Tasman. The subject aircraft was used as a flying billboard, with neon letters under the wings for advertising – in this case, a film. Tasman actually included some glow-in-the-dark pigment for the 3D-printed letters but I couldn't get it to adhere properly,so went with white. The mounting frames were also 3D-printed and included in the kit (they're marginally too large but oh well). I re-scribed the panel lines (there weren't many), replaced the side windows with clear acetate, replaced the mis-shapen props, and rigged the model with Uschi Van DerRosten fine thread.